"Important: ControlFLASH Plus only supports the firmware update for devices supporting the Common Industrial Protocol (CIP). "ControlFLASH Plus is a more feature-packed version of ControlFLASH, enabling you to flash one or multiple devices at once, manage firmware revisions and locations, and manage device revisions and favorites." That's not the sole reason they exist, just a main one.įrom a previous post of mine, quoting Rockwell. They both now use DMK files which just provide a method of individually downloading and registering firmware kits without the need to also install a particular version of ControlFLASH software. ControlFLASH Plus is an updated version of ControlFLASH, but it does not replace it. They were introduced with a newer version of ControlFLASH. The newer DMK files were not introduced with ControlFLASH Plus, or solely to be used with ControlFLASH Plus. They are both Windows based software products and both use DMK files. I'm not sure where you are getting the "dos" reference from, but the above thinking would be incorrect, my friend. The above is in case anyone else comes across this error and their head starts getting itchy too! So luckily I had some time to sort this in advance. It'll be next week before they go into the MCC with 3 phase power applied to finish the flash update to the power sections. When you point the USB App to the above extracted nvs file, you get the error above.įrom the technote, you may either download the attached correctly named files, or manually edit the files, which I did.Īlso edit the NVS file using Notepad and change the incorrect "DataFileName" entry used to reference the renamed BIN file.Īfter these changes the error was gone and I successfully flash updated all the drive modules. In there it says the downloaded DMK file "Firmware_for_PowerFlex_525_v7.001.dmk" contains non-standard filenames for the packed NVS & BIN files contained inside. How it didn't show up yesterday, I don't know? PowerFlex 525 Flashing Update Error for v7.001 When Using Logix PLC Firmware Supervisor or The PF52XUSB.EXE Application Eventually I went back to the KB and this time came across the following. I had another go today and struggled most of the day once more (just 4:30pm here now). Searched the KB a good bit and found a few articles which mostly told me things I already knew or had already tried. This should work but instead I was getting a message stating "Error reading bin file " and crapping out. Therefore, we must use the DMK Extraction Tool to first extract the older NVS & BIN files from the DMK file, and then point the USB App to the NVS file within the ControlFlash directories. The USB App, which we open by running the "PF52XUSB.EXE" file directly off the drive control module connected via USB to our PC, will not recognize DMK files. The downloaded firmware file is of the newer *.DMK file type which I've explained here before a couple of times. Two-day head scratcher here trying to flash upgrade a bunch of out-of-the-box FRN 5.002 PF525 drives to latest FRN 7.001 (at time of writing). Quick one passing through as I'm quite busy at the moment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |